INF Sanctuary Clan side Key

If you find out some good information or write a guide, post it here.

Moderator: fleat

Posts: 376
Joined: Mon Sep 29, 2008 3:17 am
Location: U.S.A

INF Sanctuary Clan side Key

Postby Micaiahu » Sat Aug 15, 2015 7:04 am

grab mission from NPC in garden - located near save point (Forrester Gal Zean) , to get key you need kill 9 mobs :

1 step - kill Fortuitous Man-Lum Mord

he is located in 3000x900 in unradeemed village

2 step - kill Follower Eckel Wox Mord

located in Morodeth temple - right side Properth room

3 step - kill Fortuitous Man-Fes Mord

is located in second room in Morodeth temple (left side room)

4 step - kill Hypnagogic Yutt- Chi Mord

is located in second room in Morodeth temple (middle room)

5 step - kill Celeth Kuir ,The Custiodan

dungeon near Vanya temple (205 custiodans), or unradeemed village - near Dark Marshes

6 step - kill Erath Suir ,The Custiodan

unradeemed village 2700x900 (Dark Marshes) left from entrace, near wall

7 step - kill Properth

all know where :D

8 step - kill Omega

all know where :D

9 step -kill Morodeth

and grab you perm key :)

gona update this a bit later

Respawn time for Properth is 90 minutes (after its last spawn). In inferno, you do not need to leave dungeon for timer reset.

Once you pull and finish Properth, a small mob pops and you feed him with 6 inisignias. Just open trade window with him directly (no need to listen to conversation) and give him the 6 insignias. Do not close the talk window before the mob tells you something like "take the beast". Then, Omega pops on platform. Once you pull and finish Omega, Morodeth pops on platform.

For the final bosses, tricky part is the pulling. A good team can take down the bosses one by one, but with adds it gets difficult.

The way bosses behave has changed in some previous patch. We did it several times today and failed until the last one. The current working hypothesis of the best way to pull is:
Step 1. After the boss spawn, wait exactly 7 minutes for the adds to despawn but before boss despawn. MP should pre-target boss for NSD in the future. (I am not quite sure about whether or not to wait for 7 minutes, but i do. Anyone please confirm this & talk more about the details?)
Step 2. Shoot or debuff pull the boss, run W from the WN exit of boss room and zone.
Step 3. After zone, wait 15 seconds or so until adds lose aggro (if there is any. can check on map).
Step 4. Puller zone back through the WS entrace of the faction room. Once puller enters faction room, the pulled boss would wrap in (without adds) and the team can then take down the boss without adds. MP should NSD the boss right away.

If at Step 2 you DOT pull instead of range or debuff pull, the boss will zone out of the room with the puller and starts to hit the puller. Therefore, if you DOT pull, you may want to first clean the 4 or so mobs outside faction room. When puller zone out of faction room, boss will probably zoom with him but the adds possibly do not. Then the team can finish the boss outside faction room. If for any reason the boss does not zone together with the puller, all team members re-enter faction room, especially the puller re-enter faction room in 15 seconds or so (when adds lost aggro?).

Note that the bosses despawn fast. If the puller is down, the time is takes from garden back to faction room is about the same time it takes the bosss to despawn. Even if team members try to keep aggro from the bosses, bosses still despawn fast. Therefore you had better have a second backup puller or run like hell back to faction room if puller is down. Even if the puller makes it in time from garden before boss despawn, the remaining adds (on or near the platform to the E side of room) if not despawned may instant aggro puller and possibly kill the puller again before he starts to pull the boss. The adds hit for about 2.5K and the boss hits for about 3.5K. Therefore puller needs to be prepared for more difficult pulling whenever anything goes wrong.

Anyway, it's the best to have a high level puller outside mission team so that even if the puller dies, mission team can still survive and continue with second puller.

I am not sure if this is the best way. If anyone knows better ways please advise. Thank you.

Return to “Knowledge Center”

Who is online

Users browsing this forum: No registered users and 1 guest